Details Requirements Assignment | Work Order Requirements Assignment

Details Requirements Assignment are two transfer functions as shown in Figure 1. transfer function 1 has an equation (tms+1)/(kms+km) transfer function 2 has an equation Details Requirements Assignment | Work Order Requirements Assignmentkm/(tms^2 + s) whenever the parameters km and tm in transfer function 2 in the SIMULINK BLOCK CHANGES, the parameters km and tm in transfer function 1 should also change at the same time with the same values automatically and accordingly in the Simulink.

Bydefault, the transfer function blocks parameters km should be equal to 0.4 and tm should be equal to 2.7763in both block and then when user change the defaulted values to a new value in the Transfer function block 2 in Simulink (NOT IN THE MATLAB COMMAND MANUEas shown in figure 2 in the second page), the parameters values in the transfer function block 1 in Simulink should also be updated with the same values.So, it is like user is actually dealing with the transfer function block 2 (which is a motor connected to a dynamic load). As it is a motor connected to a dynamic load, it means when the load changes the parameters values will change inside the block, so in order to assume it as interfacing this with the hardware the user should change the values in the transfer functionnot in the Matlab command manue.

Details Requirements Assignment | Work Order Requirements Assignment

This assignment should be done using the knowledge shown in the below link.

https://www.mathworks.com/matlabcentral/answers/93681-how-do-i-model-a-transfer-function-with-coefficients-that-vary-with-simulation-time-in-simulink-7-5

To do this assignment correctly please follow the above link. These are the ONLYways for this assignment to be accepted.

                   “the solution shown in figure 2 is not the correct way of doing this project and will NOT BE ACCEPTED”.